AREXAL® - Pro - Beton
Our help tool for quantity calculation:
Don't know how much you should order?
simply & conveniently use our
Permanent surface protection and up to 20cm deep penetrating, permanent impregnation (No chemicals or chlorides), lasting protection of your structure.
AREXAL®-Pro-Beton strengthens concrete surfaces and protects them against severe wear, chlorides, and aggressive liquids.
The protection is breathable, long-lasting, and acid-resistant.
AREXAL®-Pro-Beton is a surface sealant and protective treatment for vulnerable concrete surfaces, such as industrial floors and parking garage levels.
AREXAL®-Pro-Beton is also used for strengthening surfaces and binding dust during the grinding and polishing process of concrete floors.
The result is a very resistant and scratch-proof surface.
AREXAL®-Pro-Beton penetrates deeply into capillaries, microcracks, and pores. A chemical reaction between salts and minerals forms a very hard calcium silicate hydrate. Consequently, a crystalline structure forms, preventing water penetration but allowing the escape of vapors (diffusion). As the protection penetrates deeply into the concrete, it is resistant to external influences like abrasion and impacts.
A treatment increases the durability (abrasion resistance) of new concrete by more than 35 percent and strengthens older, weather-exposed concrete, mortar, and self-leveling cement-based floor screeds. The treated surface becomes slightly water-repellent (hydrophobic) after the final treatment. For very damp materials, a pretreatment for deep action with other products from the AREXAL® series is recommended.
Application Areas
- Concrete in harsh environments
- Roads, bridges, tunnels
- Parking lots and garages
- Water supply and sewage systems
- Industrial and material storage floors
- Marine environments
- Vehicle wash areas and workshops
- Cold storage rooms
- Agricultural silos
- Biogas plants
- Sawmills, paper mills
- Recycling and waste facilities
- Balconies, stairs
Advantages
- easy, fast, and trouble-free to apply
- odorless
- environmentally friendly
- breathable
- acid-resistant
- UV-resistant
Application
AREXAL®-Pro-Beton is delivered ready for use and does not need to be mixed or diluted with other liquids. Shake the container before use. The surface to be treated must be free of dust, paint, or other coatings that could impair the material's absorbency.
Repair damages or visible cracks (>1.0 mm) before treatment. Protect glass, aluminum, and polished or painted surfaces from etching. If splashes occur, immediately rinse the affected areas with water and if necessary, clean with an alkaline solution.
The temperature during application and for the following 24 hours must be ≥ +5°C. Avoid direct sunlight during application. For easy processing, use a commercial low-pressure sprayer or a roller. Apply the product at least twice at intervals of 5–15 minutes between each application until complete saturation of the material is achieved. Note that the spray mist can spread very far during application and can damage glass surfaces.
On horizontal concrete surfaces, AREXAL®-Pro-Beton can be poured out and spread with a rubber squeegee, brush, or mop. Avoid forming dry spots during treatment. Full saturation is achieved after about 20–30 minutes. Remove residues, as otherwise, shiny or white spots could form.
| Content: | 5 Liters |
|---|---|
| GHS: |
   |
| Recommended Tools: |
work gloves protective mask - FFP2 safety glasses pressure sprayer (water) |
Produkt Downloads
| Datenblatt | herunterladen |
Login